Current issue: 53(4)
Under compilation: 54(1)
This study examined a theoretical model for stand structures from the volumes of pulpwood and saw logs of clear-cut stands. The average stem size was used to estimate the number of cut trees. The distribution was solved using nonlinear derivative-free optimization. The truncated 2-parameter Weibull distribution was used to describe the stand structure of the commercial stems. This method was first tested with harvester data collected from seven clear-cut stands in southern Finland. Validation included reliability in the stand characteristics and goodness-of-fit of the species-specific distributions. The distributions provided unbiased estimates for the saw log volume, while the bias in the estimated pulpwood volume was 2%. The standard stand characteristics from the Weibull distributions corresponded notably well with the harvester data. A Kolmogorov-Smirnov (KS) test rejected two distributions out of 21 cases, when the accurate input variables were available for the theoretical model. The results of the study suggest that the presented method is a relevant option for predicting the stand structure. In practice, the reliability of the presented method was dependent on the quality of the information available from the stand prior to cutting. With a timber trade data set, the solution for the distribution for a clear-cut section was found. The goodness-of-fit was dependent on the accuracy of the visually assessed timber trade variables. Especially the average stem size proved difficult to assess due to high number of understorey pulpwood stems. Due to overestimated average stem sizes, the solved number of harvested trees was underestimated. Less than 50% of the distributions predicted for clear-cut sections passed the KS test.
Accurate timber assortment information is required before cuttings to optimize wood allocation and logging activities. Timber assortments can be derived from diameter-height distribution that is most often predicted from the stand characteristics provided by forest inventory. The aim of this study was to assess and compare the accuracy of three different pre-harvest inventory methods in predicting the structure of mainly Scots pine-dominated, clear-cut stands. The investigated methods were an area-based approach (ABA) based on airborne laser scanning data, the smartphone-based forest inventory Trestima app and the more conventional pre-harvest inventory method called EMO. The estimates of diameter-height distributions based on each method were compared to accurate tree taper data measured and registered by the harvester’s measurement systems during the final cut. According to our results, grid-level ABA and Trestima were generally the most accurate methods for predicting diameter-height distribution. ABA provides predictions for systematic 16 m × 16 m grids from which stand-wise characteristics are aggregated. In order to enable multimodal stand-wise distributions, distributions must be predicted for each grid cell and then aggregated for the stand level, instead of predicting a distribution from the aggregated stand-level characteristics. Trestima required a sufficient sample for reliable results. EMO provided accurate results for the dominating Scots pine but, it could not capture minor admixtures. ABA seemed rather trustworthy in predicting stand characteristics and diameter distribution of standing trees prior to harvesting. Therefore, if up-to-date ABA information is available, only limited benefits can be obtained from stand-specific inventory using Trestima or EMO in mature pine or spruce-dominated forests.
The following treatments were compared in three Scots pine (Pinus sylvestris L.) reforestation areas on a scarified moist mineral-soil site in southern Finland, planted with 1+1 bareroot stock in spring 1987: (a) no weed control treatment; (b) mulching with a fibre slurry produced by mixing wastepaper with water and applied 1 cm deep to an area of 60 cm in diameter around the seedling soon after planting; (c) glyphosate (at 2 kg ha-1) sprayed on a 1 m2 spot around the seedling in early August 1987; (d) terbuthylazine (at 10 kg ha-1) applied as (c). Monitoring of the trials over a 4-year period between 1987–90 showed that none of the treatments reduced surface vegetation to an extent that would have benefited pine. The percentage cover development of the vegetation, dominated by Agrostis capillaris, Calamagrostis arundinaceae, Deschampsia flexuosa, Festuca ovina, Epilobioum angustifolium and Pteridium aquillinum, followed much the same pattern in all treatments, with (c) slightly favouring forbs. Survival of pine at the end of the study period was about 90%, with non-significant differences between treatments. Mulching and terbuthylazine treatment slightly reduced seedling height growth in the second year. Growth was better in glyphosate treatment than in terbuthylazine treatment in the lowest (<30%) and the highest (>60%) pre-treatment weed cover classes, and in the latter also better than in untreated control. Mulching gave variable results; at its best it provided also good control of weeds for several years, without, however, improving the initial development of pine in these trials.