Current issue: 54(2)

Under compilation: 54(3)

Impact factor 1.683
5-year impact factor 1.950
Silva Fennica 1926-1997
1990-1997
1980-1989
1970-1979
1960-1969
Acta Forestalia Fennica
1953-1968
1933-1952
1913-1932

Articles by Ganbaatar Chultem

Category: Research article

article id 10284, category Research article
Togtokhbayar Erdene-Ochir , Futoshi Ishiguri, Ikumi Nezu, Bayasaa Tumenjargal, Bayartsesteg Baasan, Ganbaatar Chultem, Jyunichi Ohshima, Shinso Yokota. (2020). Utilization potential of naturally regenerated Mongolian Betula platyphylla wood based on growth characteristics and wood properties. Silva Fennica vol. 54 no. 3 article id 10284. https://doi.org/10.14214/sf.10284
Highlights: Wood with high density and high compressive strength can be obtained near to the bark of Betula platyphylla trees; Basic density of B. platyphylla wood may be predicted by the stress-wave velocity of stems; Growth characteristics are positively correlated with stress-wave velocity and basic density; Early evaluation of basic density is possible when using the wood at 2 cm from the pith: A significant between-site variation was found in the basic density at the position from the 1st to the 15th annual ring from the pith; Wood from B. platyphylla trees grown in Mongolia may be used for industrial products equally to the same species in other countries.

To preliminary evaluate the potential wood utilization of Betula platyphylla Sukaczev trees naturally regenerated in Mongolia, growth characteristics (stem diameter and tree height), wood properties (annual ring width, basic density, and compressive strength parallel to grain at the green condition) of core samples, and stress-wave velocity in stems were investigated for Betula platyphylla trees grown naturally in three different sites in Selenge, Mongolia. Betula platyphylla trees, naturally grown in Nikko, Japan, were also examined to compare wood properties between the two regions. The mean values of stem diameter, tree height, stress-wave velocity of stems, annual ring width, basic density, and compressive strength parallel to grain at green condition in Mongolian B. platyphylla were 17.6 cm, 14.1 m, 3.50 km s–1, 1.27 mm, 0.51 g cm–3, and 20.4 MPa, respectively. Basic density and compressive strength were decreased first from the pith, and then gradually increased toward the bark. The wood properties of B. platyphylla trees grown naturally in Mongolia were similar to those in B. platyphylla trees grown in Japan. Growth characteristics, especially stem diameter, were positively correlated with the stress-wave velocity of stems and basic density. Early evaluation of basic density in B. platyphylla trees is possible by using wood located 2 cm from the pith. Basic density at the position from the 1st to the 15th annual ring from the pith showed significant between-site differences in Mongolian B. platyphylla. Based on the results, it is concluded that the wood of B. platyphylla trees grown in Mongolia may be used for industrial products as well as those from similar species in other countries.

  • Erdene-Ochir , School of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan; United Graduate School of Agricultural Science, Tokyo University of Agriculture and Technology, Fuchu, Tokyo 183-8509, Japan; Training and Research Institute of Forestry and Wood Industry, Mongolian University of Science and Technology, Ulaanbaatar 14191, Mongolia ORCID ID:E-mail: togtokhbayarerdeneochir@gmail.com
  • Ishiguri, School of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: ishiguri@cc.utsunomiya-u.ac.jp (email)
  • Nezu, School of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: zoo-sk3.primo@outlook.jp
  • Tumenjargal, School of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan; United Graduate School of Agricultural Science, Tokyo University of Agriculture and Technology, Fuchu, Tokyo 183-8509, Japan; Training and Research Institute of Forestry and Wood Industry, Mongolian University of Science and Technology, Ulaanbaatar 14191, Mongolia ORCID ID:E-mail: t_bayasaa88@yahoo.com
  • Baasan, Training and Research Institute of Forestry and Wood Industry, Mongolian University of Science and Technology, Ulaanbaatar 14191, Mongolia ORCID ID:E-mail: bayartsetseg@must.edu.mn
  • Chultem, Training and Research Institute of Forestry and Wood Industry, Mongolian University of Science and Technology, Ulaanbaatar 14191, Mongolia ORCID ID:E-mail: ganbaatar_ch@must.edu.mn
  • Ohshima, School of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: joshima@cc.utsunomiya-u.ac.jp
  • Yokota, School of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: yokotas@cc.utsunomiya-u.ac.jp
article id 10002, category Research article
Bayasaa Tumenjargal, Futoshi Ishiguri, Haruna Aiso-Sanada, Yusuke Takahashi, Bayartsetseg Baasan, Ganbaatar Chultem, Jyunichi Ohshima, Shinso Yokota. (2018). Geographic variations of wood properties of Larix sibirica naturally grown in Mongolia. Silva Fennica vol. 52 no. 4 article id 10002. https://doi.org/10.14214/sf.10002
Highlights: Significant differences (p  < 0.01) among five stands were found in tree height, stress-wave velocity of stems, dynamic Young’s modulus of stems and logs, annual ring width, and latewood percentage, suggesting that there was geographic variation of mechanical properties of wood in Larix sibirica (Münchh.) Ledeb. grown in Mongolia; Dynamic Young’s modulus of logs in L. sibirica trees can be predicted by stress-wave velocity of stems; Stem diameter of L. sibirica naturally grown in Mongolia is closely related to radial growth at initial stage of growth, especially within the first twenty years.

Geographic variations in growth, stress-wave velocity of stem, dynamic Young’s modulus of stems and logs, annual ring width, latewood percentage and basic density were investigated for Larix sibirica (Münchh.) Ledeb. naturally grown in Mongolia. A total of 250 trees with 20 to 30 cm in stem diameter at a height of 1.3 m above ground level were selected from each natural stand in five different provenances in Mongolia. In addition, five trees in each stand were cut for measuring dynamic Young’s modulus of stems and logs, annual ring width, latewood percentage and basic density. Mean values of stress-wave velocity of stems in each stand ranged from 2.92 to 3.41 km s–1, and the mean value of five stands was 3.23 km s–1. Mean values of dynamic Young’s modulus of logs in each stand ranged from 5.17 to 9.72 GPa. A significant correlation (r = 0.798, p < 0.01) was found between stress-wave velocity of stems and dynamic Young’s modulus of logs. Among the five stands, the highest and the lowest values of average annual ring number were 193 and 44, respectively. Mean values of basic density in five trees within each stand were examined and ranged from 0.52 to 0.56 g cm–3. Significant differences among five stands were found in tree height, stress-wave velocity of stem, dynamic Young’s modulus of stems and logs, annual ring width and latewood percentage, suggesting that L. sibirica trees naturally grown in Mongolia have geographic variations in mechanical properties of wood.

  • Tumenjargal, Faculty of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan; United Graduate School of Agricultural Science, Tokyo University of Agriculture and Technology, Fuchu, Tokyo 183-8509, Japan; Research and Training Institute of Forestry and Wood Industry, Mongolian University Science and Technology, Ulaanbaatar 14191, Mongolia ORCID ID:E-mail: t_bayasaa88@yahoo.com
  • Ishiguri, Faculty of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: ishiguri@cc.utsunomiya-u.ac.jp (email)
  • Aiso-Sanada, Forestry and Forest Products Research Institute, Tsukuba, Ibaraki 305-8687, Japan ORCID ID:E-mail: haiso@ffpri.affrc.go.jp
  • Takahashi, Faculty of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: zo.r.by0814@gmail.com
  • Baasan, Research and Training Institute of Forestry and Wood Industry, Mongolian University Science and Technology, Ulaanbaatar 14191, Mongolia ORCID ID:E-mail: bayartsetseg@must.edu.mn
  • Chultem, Research and Training Institute of Forestry and Wood Industry, Mongolian University Science and Technology, Ulaanbaatar 14191, Mongolia ORCID ID:E-mail: ganbaatar_ch@must.edu.mn
  • Ohshima, Faculty of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: joshima@cc.utsunomiya-u.ac.jp
  • Yokota, Faculty of Agriculture, Utsunomiya University, Utsunomiya, Tochigi 321-8505, Japan ORCID ID:E-mail: yokotas@cc.utsunomiya-u.ac.jp

Register
Click this link to register for Silva Fennica submission and tracking system.
Log in
If you are a registered user, log in to save your selected articles for later access.
Contents alert
Sign up to receive alerts of new content
Your selected articles

Committee on Publication Ethics A Trusted Community-Governed Archive