Current issue: 53(4)
Operating conditions affecting the quality of spot mounding by Bracke continuously advancing mounders were investigated on 66 regeneration areas (124 ha) in eastern Finland. The quality of mounds was classified as suitable (good or acceptable after additional compression) or unsuitable for planting. Models were constructed for the number of suitable planting spots obtained per hectare (good and acceptable mounds), the probability of successful mounding (≥1600 planting spots ha–1) and the probability of creating a suitable mound as a function of terrain, site and soil characteristics, as well as slash conditions (removed, fresh or dry logging residues). The average number of mounds created was 1892 ± 290 mounds ha–1, of which 1398 ± 325 mounds ha–1 (74%) were classified as suitable for planting. The quality of spot mounding was reduced by steep terrain, a thick humus layer and fresh logging residues. Stoniness and soil texture also affected the number of planting spots created. Mounding after logging residues had dried increased the number of planting spots by 191 spots ha–1 compared with mounding in the presence of fresh residues. Removing residues did not significantly increase the number of planting spots compared with mounding amongst dry residues. A thick humus layer, very stony soil, steep slopes and valley terrain decreased the number of planting spots by 150–450 spots ha–1. The number and quality of mounds varied considerably according to the operating conditions, but with careful selection of timing and sites the quality obtained by a continuously advancing mounder can be improved.
The use of a white-rot fungus, Chondrostereum purpureum (Pers. Ex Fr.) Pouzar, as a biocontrol agent against sprouting has been studied with good results. The aim of the study was to investigate the efficacy of two pre-commercial thinning machines, Tehojätkä and Mense, to spread an inoculum of C. purpureum as a biocontrol agent on freshly cut birch (Betula pendula Roth and B. pubescens Ehrh.), European aspen (Populus tremula L.), rowan (Sorbus aucuparia L.), and goat willow (Salix caprea L.) stumps (the fungal treatment) and compare that to the control (cutting only, done by Tehojätkä). Efficacy was investigated in terms of stump mortality and the number of sprouts per stump. This study was conducted in one stand and sprouting was investigated for three years after treatment. The fungal treatment resulted in higher mortality of stumps (34.0% for Tehojätkä and 41.5% for Mense after three years), compared to the control (13.4%). However, the fungal treatment did not decrease the number of sprouts per stump compared to the control. The low occurrence of basidiomata indicates that the accuracy of the spreading mechanism was not satisfactory, causing low mortality figures for the fungal treatment compared to previous studies. In the future, this mechanized method may provide a promising alternative in sprout control if the spreading mechanisms, the accuracy of the treatment, and consequently the efficacy could be improved.