Current issue: 53(2)

Under compilation: 53(3)

Impact factor 1.683
5-year impact factor 1.950
Silva Fennica 1926-1997
1990-1997
1980-1989
1970-1979
1960-1969
Acta Forestalia Fennica
1953-1968
1933-1952
1913-1932

Articles containing the keyword 'pruning saw'.

Category: Research article

article id 10052, category Research article
Pentti Niemistö, Harri Kilpeläinen, Henrik Heräjärvi. (2019). Effect of pruning season and tool on knot occlusion and stem discolouration in Betula pendula – situation five years after pruning. Silva Fennica vol. 53 no. 1 article id 10052. https://doi.org/10.14214/sf.10052
Highlights: The occlusion was the fastest in the case of small living branches of fast growing trees pruned in springtime; Occlusion was quicker after saw pruning than after secateurs pruning, due to shorter knot stubs; Branches that were pruned in living state occluded faster than the ones pruned as dead; Dead branches hit down with a stick occluded slowly.

This paper investigates and models the effects of pruning season and tool on wound occlusion with varying tree and branch characteristics of silver birch (Betula pendula Roth) stems at the pruning height of 0−4 metres. Dates of eight secateurs prunings, three saw prunings and two sticks prunings as well as unpruned control were tested in permanent plots on four sites. Knot occlusion and discolouration in stemwood were measured from about 1600 studied knots of 112 sample trees felled five to six years after pruning in 2010. Knot occlusion rate was modelled according to pruning tool, date, tree growth, and branch characteristics. The occlusion was the fastest in trees pruned in spring or early summer, and the slowest in trees pruned in autumn. Stubs of living branches occluded faster than the dead ones with the same diameter. Saw pruning resulted in clearly better occlusion rates than secateurs pruning, caused by the shorter knot stubs after saw pruning. Hitting dead branches away with a stick resulted in the worst occlusion status. The colour defects spread more often upward from the knot than downward. Discolouration in stemwood was detected more frequently near to the pruned branches than the unpruned ones, and more widely near to the stubs of dead branches than the living ones. Most saw and secateurs pruned branches were completely occluded during the experiment, so these prunings were suitable for all branches under 20 mm in diameter, and for living branches even up to 30 mm in fast-growing trees.

  • Niemistö, Natural Resources Institute Finland (Luke), Natural resources, Kampusranta 9 C, FI-60320 Seinäjoki, Finland ORCID ID:E-mail: pentti.niemisto@luke.fi (email)
  • Kilpeläinen, Natural Resources Institute Finland (Luke), Production systems, Yliopistokatu 6 B, FI-80100 Joensuu, Finland ORCID ID:E-mail: harri.kilpelainen@luke.fi
  • Heräjärvi, Natural Resources Institute Finland (Luke), Production systems, Yliopistokatu 6 B, FI-80100 Joensuu, Finland ORCID ID:E-mail: henrik.herajarvi@luke.fi
article id 258, category Research article
Ursula Schatz, Henrik Heräjärvi, Kari Kannisto, Matti Rantatalo. (2008). Influence of saw and secateur pruning on stem discolouration, wound cicatrisation and diameter growth of Betula pendula. Silva Fennica vol. 42 no. 2 article id 258. https://doi.org/10.14214/sf.258
The aim of this case study was to compare the impacts of saw and secateur pruning on silver birch (Betula pendula Roth). Data were collected from two saw pruned stands in 2005, and one secateur pruned stand in 2003. All the stands were located in southern Finland. The sample stems were felled, and their butt logs were sawn into flitches, whose knot features and colour defects were measured. In addition, discs were sawn from each stem in order to study the annual ring widths. In this material, pruning with secateurs appeared to cause less colour defects than pruning with a saw. Irrespective of the pruning method used, the colour defects in the stem wood were at their largest in cases where the basal knob or the stem bark appeared to be damaged by pruning. Colour defects spread mainly towards the pith, only in a few cases towards the stem surface. The cicatrisation time of the knots as well as the length of the bark stick remaining inside the stem did not show significant differences between the two pruning methods. Pruning of the lowest living branches appears to have no effect on the diameter growth of silver birch trees.
  • Schatz, Peltotievantie 27, FI-99440 Leppäjärvi, Finland ORCID ID:E-mail:
  • Heräjärvi, Finnish Forest Research Institute, Joensuu Research Unit, P.O. Box 111, FI-80101 Joensuu, Finland ORCID ID:E-mail: henrik.herajarvi@metla.fi (email)
  • Kannisto, Finnish Forest Research Institute, Parkano Research Unit, Kaironiementie 54, FI-39700 Parkano, Finland ORCID ID:E-mail:
  • Rantatalo, Peltotievantie 27, FI-99440 Leppäjärvi, Finland ORCID ID:E-mail:

Register
Click this link to register for Silva Fennica submission and tracking system.
Log in
If you are a registered user, log in to save your selected articles for later access.
Contents alert
Sign up to receive alerts of new content
Your selected articles

Committee on Publication Ethics A Trusted Community-Governed Archive