John R. Moore 
,
Andrew J. Lyon,
Gregory J. Searles,
Leena E. Vihermaa
The effects of site and stand factors on the tree and wood quality of Sitka spruce growing in the United Kingdom
Moore J. R., Lyon A. J., Searles G. J., Vihermaa L. E. (2009). The effects of site and stand factors on the tree and wood quality of Sitka spruce growing in the United Kingdom. Silva Fennica vol. 43 no. 3 article id 195. https://doi.org/10.14214/sf.195
Abstract
The extent and sources of variation in the wood quality of Sitka spruce (Picea sitchensis (Bong.) Carr.) were quantified using data collected from 64 stands in northern Britain. These stands were selected on the basis of elevation, latitude, longitude, yield class, initial spacing and the presence or absence of thinning. Dynamic modulus of elasticity (MOE) was calculated from measurements of stress wave velocity made on standing trees and qualitative descriptions were made of stem form. Dynamic MOE of individual trees ranged from 3.81 kN/mm2 up to 12.29 kN/mm2, with a mean of 7.71 kN/mm2. Approximately 55 percent of the variation in dynamic MOE was due to differences between individual trees within a site, while 35 percent was due to differences between sites. The remaining 10 percent was due to differences between the measurements made on opposite sides of each tree. Variation in dynamic MOE at the site level was significantly influenced by yield class, elevation as well as by a number of the interactions between these factors and latitude, longitude and initial spacing. A multiple regression model incorporating these variables was able to explain 45 percent of the variation in dynamic MOE. Ramicorn branches were the most commonly recorded defect (37.2% of all live trees), followed by stem scarring and basal sweep (6.9% and 6.3%, respectively). Dynamic MOE was not influenced by stem straightness (p = 0.10) which indicates the utility of stress wave velocity measurements for segregating Sitka spruce stands based on potential grade recovery.
Keywords
wood quality;
acoustics;
timber properties;
wood stiffness
-
Moore,
Centre for Timber Engineering, Napier University, 10 Colinton Road, Edinburgh EH10 5DT, United Kingdom
E-mail
j.moore@napier.ac.uk
- Lyon, Centre for Timber Engineering, Napier University, 10 Colinton Road, Edinburgh EH10 5DT, United Kingdom E-mail ajl@nn.uk
- Searles, Centre for Timber Engineering, Napier University, 10 Colinton Road, Edinburgh EH10 5DT, United Kingdom E-mail gjs@nn.uk
- Vihermaa, Department of Analytical and Environmental Chemistry, University of Glasgow, Glasgow, UK E-mail lev@nn.uk
Received 23 May 2008 Accepted 11 May 2009 Published 31 December 2009
Views 3453
Available at https://doi.org/10.14214/sf.195 | Download PDF
Send to email
