M. J. Youngman, G. D. Kulasiri , I. M. Woodhead, G. D. Buchan

Use of combined constant rate and diffusion model to simulate kiln-drying of Pinus radiata timber

Youngman M. J., Kulasiri G. D., Woodhead I. M., Buchan G. D. (1999). Use of combined constant rate and diffusion model to simulate kiln-drying of Pinus radiata timber. Silva Fennica vol. 33 no. 4 article id 652. https://doi.org/10.14214/sf.652

Abstract

This paper presents the use of a combined constant drying-rate and diffusion model to simulate the drying of Pinus radiata timber under kiln-drying conditions. The constant drying-rate and diffusion coefficients of the model, which control the drying rate of individual pieces of timber, were determined from calibrating the model against the experimental drying curves obtained under the kiln-drying conditions. The experimental drying curves were obtained from the gravimetric measurements of the moisture content of timber during kiln drying. Statistical relationships were developed for the constant drying-rate and the diffusion coefficients of the model as functions of kiln temperature and the dry basis density of timber. To determine the effects of variability of timber, a simulation scheme was developed based on the model, the probability distribution of the density of timber, the equations for the constant drying-rate coefficient and the diffusion coefficient. The model and the associated simulation method provides a simple way to estimate the drying time of a stack of timber using parameters determined from experimental results for the specific timber kiln.

Keywords
simulation; timber drying; diffusion; constant drying-rate

Received 2 March 1999 Accepted 18 October 1999 Published 31 December 1999

Views 10222

Available at https://doi.org/10.14214/sf.652 | Download PDF