Timo Tahvanainen 
,
Kalle Kaartinen,
Timo Pukkala,
Matti Maltamo
Comparison of approaches to integrate energy wood estimation into the Finnish compartment inventory system
Tahvanainen T., Kaartinen K., Pukkala T., Maltamo M. (2007). Comparison of approaches to integrate energy wood estimation into the Finnish compartment inventory system. Silva Fennica vol. 41 no. 1 article id 310. https://doi.org/10.14214/sf.310
Abstract
The harvesting of energy wood from young stands is increasing as the demand for renewable wood fuel is growing. Energy wood consists of stems, tree tops, branches and needles, depending on the size of the trees and the logging method used. The current forest inventory and planning systems used in private forests in Finland do not produce estimates of energy wood components. In stands typical for energy wood harvesting, a large share of energy wood consists of trees smaller than the minimum size for pulpwood. In this study, energy wood was included into the calculation system of compartment inventory, and a procedure for simulating the thinning treatments in young stands was developed. The results for six inventory alternatives and prediction of energy wood were compared with the use of inventory material from 37 young stands that have plenty of energy wood. The measurement of additional stand characteristics and the use of a calibration estimation method was tested, as well as the use of plot-level inventory data instead of stand level data. The results showed that the measurement of the number of trees per hectare, in addition to stand basal area and mean diameter, improved the energy wood estimates. The additional minimum and maximum diameters improved the precision of the estimates, but did not affect bias. The removal estimates were more precise when plot-level data was used, rather than stand-level data. The removal estimates were higher with plot-level data. The results suggest that, in heterogeneous young stands, plot by plot prediction would give more accurate removal estimates than the calculation of a corresponding prediction at the stand-level.
Keywords
diameter distribution;
thinnings;
calibration estimation;
compartment inventory
-
Tahvanainen,
Finnish Forest Research Institute, P.O. Box 68, FI-80101 Joensuu, Finland
E-mail
timo.tahvanainen@metla.fi
- Kaartinen, University of Joensuu, Faculty of Forestry, P.O. Box 111, FI-80101 Joensuun yliopisto, Finland E-mail kk@nn.fi
- Pukkala, University of Joensuu, Faculty of Forestry, P.O. Box 111, FI-80101 Joensuun yliopisto, Finland E-mail tp@nn.fi
- Maltamo, University of Joensuu, Faculty of Forestry, P.O. Box 111, FI-80101 Joensuun yliopisto, Finland E-mail mm@nn.fi
Received 29 March 2006 Accepted 22 December 2006 Published 31 December 2007
Views 8803
Available at https://doi.org/10.14214/sf.310 | Download PDF
Send to email
